Product information

ROMPOX^®-VERKEHR V2 is high strength very slightly water permeable pavement fixing mortar.

quick, cost effective, long-lived, environmentally friendly pavement fixing mortar from natural and concrete paving stone, slabs and clinker surfaces.

Properties of ROMPOX^®-VERKEHR V2:

• for middle and highly vehicle traffic loads (up to 40 t)
• for very quick re-opening to traffic
• for joints widths from 8 mm wide and joints depth from 30 mm deep
• high strength
• very slightly water permeable
• sweeping machine resistant
• 2 component epoxy resin
• water emulsifiable
• frost resistant
• de-icing salt resistant
• weed free
• can be applied to ground temperatures of > 7 ºC

1 — clean out joints to a depth of at least 30 mm (minimum joint width 5 mm). The surface to be joint-fixed should be cleaned of all impurities before work commences. Adjoining surfaces that are not to be joint-fixed are taped off.

2-3 - pour the filler components (25 kg sack) into the mixing process. Whilst mixing, slowly add the separately packaged resin/hardener component (2 plastic bottles stuck to each other) completely into the mixture. Total mixing time at least 6 minutes.

4-6 – apply the mixed pavement fixing mortar onto the surface and roughly distribute it using a spade or metal slider. Then work it hard, deep and compactly into the joints the using a squeegee/rubber slider. Application time 15-20 minutes at working temperature of + 20ºC.

7-8 – immediately after application sweep the stone surface carefully with a coarse street broom. Then use a soft hair broom to do a final cleaning until all residual mortar has been removed from the surface. Sweeping should be done diagonally to the joint. Do not re-use swept off material.

9-11 - the freshly jointed surface needs to be protected against rain for the next 12 hours. The rain protection layer must not be laid directly onto the paved surface, this is to ensure sufficient air circulation. Safe rain protection is afforded by the specially developed ROMEX protective surface mats, that can be simply laid on the surface.During initial period a very thin film of epoxy resin remains on the stone surface and intensifies the color of the stone and protect it from dirt. This film, however, disappears from the surface in open weather and through abrasion in the coming months.

• application time: 15-20 minutes at + 20 ºC working temperature
• surface temperature: >7ºC
• at lower temperature – slow hardening
• at high temperature — quick hardening
• surface can be walked on after 12-24 hours and driven after 3 days (at approx. 20ºC surface temperature)

Detailed technical information you can find on website of company ROMEX Pflasterfugenmörtel www.romex-pfg.de

print page